I’m selecting an ROI measurement from the Measurements Table, but Openlab is not displaying either the ROI or the image that it corresponds to in the document window.

Technical Note: 128
Reads: 6505
Creation Date: 26/06/2000
Modification Date: 12/02/2004

Openlab gives you a choice of display options.

If you wish to view both the measurement overlay and the layer from which it was taken, select "Switch Layers" from the Overlay menu of the Measurements table.

If you wish to view measurements taken from the current layer only, select "Show Current Layer Only" from the Overlay menu of the Measurements Table. Make sure "Switch Layers" is deselected at the same time.