Can I use more than one Ludl controller with Openlab?

Technical Note: 198
Reads: 6160
Creation Date: 07/03/2001
Modification Date: 12/02/2004

Make sure you have all the Ludl controllers connected to serial ports. Go to the Edit menu, choose "Preferences" and set up as follows:

1. Select the Ludl icon from the options on the left hand side of the Preferences dialog and enter the correct number of controllers.

2. Save the Preferences, quit and restart Openlab.

3. Go back into the Openlab preferences and select serial ports, you should see under the devices 'Ludl 1', 'Ludl 2' etc., Assign these devices to the appropriate port.

4. Save the Preferences , quit and restart Openlab.